Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
start:plugins:selectiontools:selectiontools-usermanual [2021/07/27 11:41] adminmar [SelectByBorderDetection] DisplayArea option |
start:plugins:selectiontools:selectiontools-usermanual [2021/11/04 14:29] (current) adminmar |
||
---|---|---|---|
Line 6: | Line 6: | ||
The plugin installer can be downloaded at: [[https:// | The plugin installer can be downloaded at: [[https:// | ||
A free trial is included, and yearly licenses can be purchased on the aforementioned page.\\ | A free trial is included, and yearly licenses can be purchased on the aforementioned page.\\ | ||
- | //Selection Tools// works for Rhino 6((Rhino6.15 or later)) and Rhino7((Tested up to Rhino 7.1)). | + | //Selection Tools// works with Rhino 6((Rhino 6.15 or higher)) and Rhino7((Rhino 7.5 or higher)). |
{{page> | {{page> | ||
Line 72: | Line 72: | ||
- One object is selected for each name | - One object is selected for each name | ||
{{ : | {{ : | ||
- | ----- | ||
- | ==== SelectByBorderDetection ==== | ||
- | <WRAP center round important 60%> | ||
- | Available only for Rhino7 and later | ||
- | </ | ||
- | Tries to detect and select a room's walls. Useful for drawings with many short curves delimiting a ship's or building' | ||
- | === Walkthrough === | ||
- | - Start the command | ||
- | - Hover the model: the result is previewed in real-time | ||
- | {{ : | ||
- | === Options === | ||
- | == DetectionRange == | ||
- | Limits the detection range where the command will look for walls. Default value is 1000((Model Units)) | ||
- | == Mode == | ||
- | Two modes are available: | ||
- | * // | ||
- | * // | ||
- | == DisplayArea == | ||
- | When enabled, the area will be displayed during the preview if the polycurve creation is successful. | ||
- | {{ : |