Differences

This shows you the differences between two versions of the page.

--- start:plugins:selectiontools:selectiontools-usermanual [2021/01/11 11:27]
adminmar Added separation lines between commands
+++ start:plugins:selectiontools:selectiontools-usermanual [2021/10/28 15:20]
adminmar Command 'SelectByBorderArea' removed
@@ Line 38: / Line 38: @@
   - Select a solid((closed polysurface))
   - Enter the tolerance
-  - Every solids with the same volume in the model will be selected
+  - Every solid with the same volume in the model will be selected
 {{ :start:plugins:selectiontools:selectbyvolume.gif?nolink |}}
+<WRAP center round info 80%>
+The command does not look for volumes inside of blocks. However, it is possible to select a volume belonging to a block when picking the original solid.
+</WRAP>
 === Preselection ===
 Preselection is allowed if one and only one solid((closed polysurface)) is preselected.
@@ Line 59: / Line 62: @@
 ===  Options ===
 == Minimum object duplicate count ==
-A minimum number can be set. For exemple if set to 3, the selection will ignore duplicated items when there are only two of them.
+A minimum number can be set. For example, if set to 3, the selection will ignore duplicated items when there are only two of them.
 == Tolerance ==
 Optional tolerance
 -----
 ==== SelectOneObjByName ====
-Selects only one object per existing name in the whole model. Useful when readying the model before detailled drawings.
+Selects only one object per existing name in the whole model. Useful when readying the model before making detailed drawings.
 === Walkthrough ===
   - Launch the command
   - One object is selected for each name
 {{ :start:plugins:selectiontools:selectoneobjbyname.gif?nolink |}}
------
-==== SelectByBorderDetection ====
-Tries to detect and select a room's walls. Useful for drawings with many short curves delimiting a ship's or building's rooms.
-=== Walkthrough ===
-  - Start the command
-  - Hover the model: the result is previewed in real time
-{{ :start:plugins:selectiontools:selectbyborderdetection.gif?nolink |}}
-=== Options ===
-== DetectionRange ==
-Limits the detection range where the command will look for walls. Default value is 1000((Model Units))
-== Mode ==
-Two modes are available:
-  * //SelectExistingCurves// is just a selection of existing objects
-  * //TryCreateClosedPolycurve// will always returns a closed polyline. If needed line segments may be added.