Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
start:plugins:marineweightschedule:mws-usermanual [2021/12/14 13:58] adminmar Added command ProjectWeightReportByHullSection |
start:plugins:marineweightschedule:mws-usermanual [2021/12/14 15:10] (current) adminmar |
||
---|---|---|---|
Line 133: | Line 133: | ||
=== Options === | === Options === | ||
No option available. | No option available. | ||
+ | === Scripted mode === | ||
+ | Using the command' | ||
+ | * **AxisLengthInMeters**: | ||
=== Customization === | === Customization === | ||
This command behavior can be customized, by editing some files in the install directory((If you installed from Rhino' | This command behavior can be customized, by editing some files in the install directory((If you installed from Rhino' | ||
Line 150: | Line 153: | ||
---- | ---- | ||
==== ProjectWeightReportByHullSection ==== | ==== ProjectWeightReportByHullSection ==== | ||
- | This command((From v1.2.0)) splits the model into sections, then runs [[start: | + | This command((From v1.2.0)) splits the model into sections, then runs //[[start: |
- | The resulting | + | The resulting |
+ | {{ : | ||
=== Walkthrough === | === Walkthrough === | ||
- | lorem ipsum non comprendum | + | - Run the command // |
+ | - Pick the x-axis coordinates delimiting the sections((The coordinates can be registered either by clicking on the model or by entering numbers in the command line.)). | ||
+ | - The script will split internally the curves and surfaces, and sort points and volumes by each section' | ||
+ | <WRAP center round important 90%> | ||
+ | Items((Volumes, | ||
+ | </ | ||
+ | <WRAP center round info 90%> | ||
+ | Solids((Closed polysurfaces)) __must not__ by split, because the result would be opened polysurfaces, | ||
+ | </ | ||
=== Scripted mode === | === Scripted mode === | ||
- | fluctuate net mergitur | + | Using the command' |
+ | * **AxisLengthInMeters**: | ||
+ | * **DrawSplittedGeometries**: | ||
---- | ---- | ||
==== HydrostaticReport ==== | ==== HydrostaticReport ==== |