Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
start:plugins:marineweightschedule:mws-usermanual [2021/01/07 12:09] adminmar [GBlock_GetList] |
start:plugins:marineweightschedule:mws-usermanual [2021/02/18 10:59] adminmar [HydrostaticReport] |
||
---|---|---|---|
Line 138: | Line 138: | ||
=== Walkthrough === | === Walkthrough === | ||
The hull's surface or polysurface is selected as input. | The hull's surface or polysurface is selected as input. | ||
- | Once validated, Rhino' | + | Once validated, Rhino' |
{{ : | {{ : | ||
=== Options === | === Options === | ||
Line 154: | Line 154: | ||
---- | ---- | ||
==== GBlock_SetData ==== | ==== GBlock_SetData ==== | ||
- | Add gravity center and mass informations to a block. GBlocks | + | Adds gravity center and mass informations to a block. GBlocks |
+ | <WRAP center round info 90%> | ||
+ | When using this command on an existing GBlock, its gravity center, mass information and name will be overriden. | ||
+ | |||
+ | This is the only way to edit a GBlock name or data. | ||
+ | </ | ||
=== Walkthrough === | === Walkthrough === | ||
- Start the command | - Start the command | ||
Line 181: | Line 186: | ||
Select a block by their GBlock Name. (From a list of available GBlock names) | Select a block by their GBlock Name. (From a list of available GBlock names) | ||
=== Walkthrough === | === Walkthrough === | ||
- | <WRAP center round todo 60%> | + | - Launch the command |
- | Todo | + | - Pick a GBlock name from the list |
- | </ | + | - Every instances of this GBlock will be selected in the model |
+ | {{ : | ||
==== GBlock_SelectNextMissingData ==== | ==== GBlock_SelectNextMissingData ==== | ||
- | Select | + | Selects |
=== Walkthrough === | === Walkthrough === | ||
- | <WRAP center round todo 60%> | + | - Launch the command |
- | Todo | + | - The commands loops between the non-GBlocks instances in the model. (Press escap to leave) |
- | </ | + | {{ : |
+ | |||
+ | ==== GBlock_Rename ==== | ||
+ | Renames a GBlock definition (Every instances will be renamed) | ||
+ | === Walkthrough === | ||
+ | - Launch the command | ||
+ | - Pick a Gblock from the list | ||
+ | - Enter a new name for the GBlock |